HORIBA Redox Replacement Electrodes – Quickly Restore Reliable ORP Measurements
Ensure redox measurement accuracy through targeted replacement – buy online now
Redox electrodes (ORP) are permanently exposed to chemical stress during operation and can lose accuracy over time. With suitable HORIBA redox replacement electrodes, you can reliably restore the functionality of your measurement system.
Suitable replacement sensors for existing systems
While measuring devices can be calibrated, the electrode itself is a wear part. If its surface changes or it reacts sluggishly, replacement is usually the only solution.
HORIBA replacement electrodes provide a perfectly fitting solution to quickly restore existing systems to a reliable performance level.
When should a redox electrode be replaced?
-
Unstable or implausible measurement values
Fluctuating ORP values make evaluation more difficult. Replacement ensures clear and reliable results. -
Delayed response to changes
The electrode reacts more slowly than usual. New sensors once again provide direct measurement values. -
Aging due to chemical stress
Disinfection processes place continuous strain on the electrode. Replacement restores measurement quality.
Typical application areas
- Replacement of redox electrodes in existing measurement systems
- Monitoring of disinfection processes
- Water treatment and process control
- Laboratory and on-site measurements
Your advantages
- Perfectly fitting HORIBA redox replacement electrodes
- Fast restoration of stable ORP values
- Easy integration into existing systems
- Reliable measurement results for secure process control
Ensure the accuracy of your redox measurements and maintain reliable control over your processes at all times.
The HORIBA LAQUAtwin Pocket Tester series provides a comprehensive solution for immediate and precise measurement of water quality parameters directly in the field. To ensure these measurements remain reliable and accurate, it is essential to regularly check the sensors and, if necessary, replace them with spare sensors. The replacement sensors, specifically designed for the HORIBA LAQUAtwin series, cover a wide range of types for various measurements: pH, conductivity, salinity, redox (ORP), as well as ion-selective sensors for sodium, potassium, nitrate, calcium, and fluoride. Each sensor is engineered to maximize user-friendliness and accuracy, for which HORIBA is globally recognized in water quality testing. HORIBA replacement sensors ensure that users’ devices consistently deliver optimal performance and precise measurements. Advantages of HORIBA Replacement Sensors: Easy Replacement: Sensors can be quickly replaced, allowing measurements to continue without delay. High Accuracy: Replacement sensors ensure that results are exact and reliable. Comprehensive Measurement Range: Various sensor types are available to cover a wide range of water quality parameters. Durability: Sensors are designed for long service life under challenging conditions. Sensor Replacement Instructions: Follow these steps when replacing the sensor to maintain the longevity and accuracy of your HORIBA LAQUAtwin Pocket Tester: Removing the Sensor: Turn off the tester. Move the sensor slightly away from the device and lift the sensor tip. Detach the sensor completely from the tester. Installing the Sensor: Ensure the tester is turned off. Make sure the waterproof gasket is clean and intact. Mount the sensor onto the tester so that hook “A” on the back of the device fits into hole “a” on the sensor tip. Ensure the waterproof gasket is not twisted. Important: After replacing the sensor, follow the steps in the user manual of the respective tester to make the device ready for accurate measurement. (These manuals are available with the products. Calibration and, if necessary, conditioning are usually required.) How can I check if my sensor shows signs of wear? Check the sensor condition as follows: Perform a 2-point calibration. If an error occurs during calibration, this indicates that the sensor has deteriorated. In this case, it is advisable to replace the sensor. Regular checks and timely sensor replacement ensure that water quality measurements performed with the HORIBA LAQUAtwin Pocket Testers remain highly accurate and reliable. Manufacturer Part Nr. 3200997083