Piston rings and seals for WS1.00 KTW
Price on request
Product information "Piston rings and seals for WS1.00 KTW"
Clack seal and spacer set for WS 1.00 KTW, WS 1.25 KTW, and WS 1.50 KTW
The seal kit for your Clack WS 1.00 KTW, WS 1.25 KTW, and WS 1.50 KTW valvesThe Clack Seal and Spacer Kit V3005-02-KTW is the second essential wear parts kit required for a complete and sustainable overhaul of your control valve. The control piston is the moving part, while this kit forms the stationary “cylinder liner” in the valve housing. These seals are crucial for the precise separation of the different water paths during regeneration.
The perfect complement to piston replacement
The seals used in the valve housing can harden, wear out, or become damaged by dirt particles after prolonged use. This causes internal leaks, which produce the same symptoms as a worn piston: constant water flow to the waste water, reduced performance, or salty soft water. When replacing the control piston, it is strongly recommended that you also replace the V3005-02-KTW seal kit to ensure a professional and permanent repair.
Complete set for easy installation
The seal kit is supplied as a pre-assembled unit in which all sealing rings and spacers are already correctly arranged. This allows for easy and error-free “push-in” installation in the cylinder valve housing. This set is an indispensable standard replacement part for households with a water softener system with a Clack valve, as it is highly compatible with the WS 1.00 KTW, WS 1.25 KTW, and WS 1.50 KTW valve series.
Areas of application
- Complete overhaul of Clack WS 1.00 KTW, WS 1.25 KTW, and WS 1.50 KTW valves
- Elimination of internal leaks and continuous discharge into wastewater
- When replacing the control piston, this component is normally also replaced
- Valve regains precise hydraulic control
Characteristics
- Manufacturer: Clack Corporation
- Variant: Complete, stationary seal and spacer kit
- Function: Seals the chambers in the main valve cylinder
- Material: High-quality EPDM seals and low-wear plastic spacers
- Compatibility: Universally compatible with Clack WS 1.00, WS 1.25, and WS 1.50 control valves
Manufacturer's product number: V3005-02-KTW
Frequently Asked Questions
To seal the chambers in the valve cylinder and to ensure the precise separation of the water passages in the control valve.
In the event of a constant flow of water towards the waste water outlet, reduced performance or salty soft water, it is strongly recommended that the seal and spacer set is also replaced when the control piston is changed. This ensures a professional and long-lasting repair.
No, the set is supplied pre-assembled, allowing for simple ‘push-in’ installation.
Clack WS 1.00 KTW, WS 1.25 KTW and WS 1.50 KTW.
Eliminates internal leaks, restores full functionality and ensures precise hydraulic control.
High-quality EPDM seals and low-wear plastic spacers.
Without replacement, old seals may not seal the new pistons and the valve properly, leading to water loss or poor performance.
Dimensions
| Height | 7 cm |
|---|---|
| Length | 13,5 cm |
| Width | 7 cm |
Weight
| Weight | 200 g |
|---|
Other attributes
| Country of origin | US |
|---|---|
| Customs tariff number | 84819000 |